Micro SD card Storage Module SPI 5v

SD card module voor arduino en andere. SPI, 5v

1. Support Micro SD Card, Micro SDHC card (high-speed card)
2. the level conversion circuit board that can interface level is 5V or 3.3V
3. power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board
4. Communication interface is a standard SPI interface
5. 4 M2 screw positioning holes for easy installation

• Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND toground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin;
• 3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SDcard supply;
• Level conversion circuit: Micro SD card into the direction of signals into 3.3V, MicroSD card toward the direction of the control interface MISO signal is alsoconverted to 3.3V, general AVR microcontroller system can read the signal;
• Micro SD card connector: yes since the bomb deck for easy card insertion and removal.
• Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, the module is easy to install positioning, to achieve inter-module combination;