100A PCB BMS Protection/Balance Board For 18650 Battery (3,4 of 5S)

3 tot 5 cellen 100 ampere Lithium polymeer batterij laad, protectie en balance module. geschikt voor 18650 cellen. Geef je keuze op bij order opmerking. Controleer beschikbaarheid.

1.This protection board is 3s 4s 5s in common use lithium battery protection board (you can adjust for how many strings to be used)

• 5S no resistors all cells enabled
• 4S 1 resistor 4 cells enabeled
• 3S 2 resistor 3 cells enabeled

2.Specified chip, stable performance, support disconnection protection, over-current protection, over discharge protection, overcharge protection, with balance, etc.

3.Common use for “same port” and “different port”, the protection board uses 15 high-power of ultra-low resistance MOS tube (discharge of 8, charging of 7), in the same port mode can support the discharge current 60A, charging current 60A; different port mode discharge current 80A, charging current 60A.

4.Can use for LMO.Ternary lithium battery.LCO(3.7V)battery packs etc.

Parameter:

• FOR Li-POLYMER LiMnO Protect Parameter(3.6V/3.7V)
• Single cell battery overcharge protect voltage : 4.21-4.29 V
• Single cell battery overcharge protect recover voltage : 4.14-4.24 V
• Overcharge protect delay : 1.5-2.5S
• Single cell battery over-discharge protect voltage : 2.72-2.88 V
• Single cell battery over-discharge protect recover voltage : 2.9-3.1 V
• Over charge protective current:100A
• Over discharge protective current:100A
• Over-discharge protect delay : 0.5-1.5S
• Temperature protect : Yes,have Temperature control interface.
• Disconnect protect : Yes
• Shortage protect : Yes
• Shortage delay : 100-600 uS
• Shortage protect recover mode: Off load release.
• Constant discharge current:80A
• Synopline discharge current:60A
• Charging current:60A
• balance function:yes
• Ampere balance (Current) : 60MA
• Current balance accuracy : 4.14-4.24V